BRC-G(optical remote controller for general industries)

BRC-G

BRC-G:Receiver

Stable operation and high reliability against disturbance noise

This is a remote controller with high reliability. Operation and handling are improved. 4-point type and 12-point type are lined up and special type is also available.

Specifications

Specifications(Transmitter)

Model No.	BRC-G24T	BRC-G44T
Kind	4-point transmitter
Power source	Alkaline cell 4 pcs Battery life : approx.9 hours under continuous use Power switch and automatic power-off function are provided(It will be off if no key input for 30sec.)
Projecting element	Infra-red LED
Directional angle	Full angle 30°
Transmission distance	10m	20m
Transmission point	4 points
Transmission method	Transmitted by transmission key(1 to 4), Double key-in is also available by changeover switch
Transmission check	Electronic buzzer(Ringing during transmitting)
Case	ABS resin(Handling part : Polyester film)
Weight	Approx. 120g

Specifications(Transmitter)

Model No.	BRC-G2BT	BRC-G4BT
Kind	12-point transmitter
Power source	Alkaline cell 4 pcs Battery life : approx.9 hours under continuous use Power switch and automatic power-off function are provided(It will be off if no key input for 30sec.)
Projecting element	Infra-red LED
Directional angle	Full angle 30°
Transmission distance	10m	20m
Transmission point	12 points
Transmission method	Transmitted by transmission key(1 to 12), Double key-in is also available by changeover switch
Transmission check	LED(Lighting during transmitting)
Case	ABS resin(Handling part : Polyester film)
Weight	Approx. 200g

Specifications(Receiver)

Model No.	BRC-G2AR	BRC-G2BR	BRC-H2AR	BRC-H2BR
Kinds	4 points	12 points	4 points	12 points
	HEAD-ON		FRONT-ON
Power source	24VDC(±20%, ripple 10% or less)
Reception element	Photo-diode
Directional angle	50°for vertical and 90°for horizontal(Full angle)
Reception method	FSK modulation, output is effective when reverse code corresponds
F number registration	Set by transmitter
Output	Data output : 4 pcs(BRC-G2AR, BRC-H2AR), 12 pcs(BRC-G2BR, BRC-H2BR), strobe : 1 pcs, photo-coupler isolation, open-collector output(Max.35V, 50mA, residual voltage Max. 1.5V) Note) It executes only when registered F No. code would coincide receiving F No.code.
Connection	Cable with connector(2m long)
Ambient illuminance	10,000lx or less(Fluorescent lamp, mercury lamp)
Ambient temperature	-10 degrees C to +50 degrees C
Ambient humidity	45 to 85%RH
Protective structure	IP66(IEC standard)

Note) While working automatic power-off function and under automatically power source would be off, even if power switch is repeated with ON→OFF→ON, there is no display on LCD. In case that, press any keys(1 to 4) after putting power source on. Turn to the normal mode and it is possible to transmit.

External dimension

●Receiver

Front-ON type

Head-ON type

※Use it when registering F No.

●Transmitter

12-point type

4-point type

Output circuit

DC35V　50mA　Residual voltage1.5V

Connection

4-point type receiver

Connector 15P
(JST PHR-15)

Shield

Colors	Pin No.	Functions
Black	1	Power 0V
Black	2	Power +V
Red	3	OUT4
Orange	4	OUT3
White/yellow	5	OUT2
Yellow	6	OUT1
White/blue	7
Green	8
Blue	9
Purple	10
Gray	11	COM
White	12	Strobe
Yellow/green	13	OUT2
Yellow/red	14
Yellow/black	15
Shield	Shield

Note) Don't use attached connector as relay terminal.

12-point type receiver

Connector (1)12P
(JST PHR-12)

Connector (1)10P
(JST PHR-10)

Shield

Connector (1)
Colors	Pin No.	Functions
Pale blue	1	Power 0V
Pink	2	Power +V
White	3	OUT8
White/black	4	OUT7
Brown	5	OUT6
Brown/black	6	OUT5
Red	7	OUT4
Red/black	8	OUT3
Orange	9	OUT2
Orange/black	10	OUT1
Yellow	11	COM
Yellow/black	12	Strobe^*

Connector (2)
Colors	Pin No.	Functions
Green	1	Strobe^*
Green/black	2	OUT12
Blue	3	OUT11
Blue/black	4	OUT10
Purple	5	OUT9
Purple/black	6
Gray	7
Gray/black	8
Pink/black	9
Pale blue/black	10
Shield	Shield

* It is short-circuited inside. ON when data would be fixed.
Note) Don't use attached connector as relay terminal.

BRC-G.pdf

More Info Price

BRS(optical remote controller for general industries, 15-point type

BRS	Optical remote controller
	MORE COMPACT SIZE AND THINNER THAN USUAL MODEL! EASY TO SEE WITH BACK-LIGHT! Compact, thin body and pocket size Transmission numbers are 15 points. 999 pcs of receiver can be chosen by ID No. setting and it is possible to make a simplified registration. Durable sheet switch is applied. Protective structure is IP64 for key operating face and IP64 for receiver.

Remote control of OHT	Notice of loading completion/transmission of destination
It can make a manual operation when testing or system troubled.	It can instruct load completion or destination from driver on automated warehouse.


Pallet No. instruction on automatic parking	Shutter opening/closing
It can instruct the specified pallet from the car.	It can make a remote control for several doors such as shutter etc. at garage or factory.

Specifications

Specifications(Transmitter)

Model No.

BRS-G2CT

Transmission distance

10m

Power source

Alkaline cell 4 pcs

Battery life

16 hours under continuous use(when not using back-light)

Display

LCD 3 digits, battery, transmission(with back-light)

Key numbers

Numerical key 1 to 15 points, setting key 3 points(Fc, Mod, Ent), Built-in electronic buzzer)

ID No. setting

Max. 999 kinds(It can be set as your option)

Setting functions

1. ID No. setting	2. Time setting for automatic power-off
3. Time setting for back-light OFF	4. Buzzer sound setting
5. Double key-in setting	6. ID No. simplified registration setting
7. Reset for setting(Initializing)

Directional angle

Full angle 30°

Wave length

870nm

Modulating method

Pulse position modulation(455kHz)

Error detection

Twice coincident system

Vibration resistance

Double amplitude 1.5mm, 10 to 55Hz, each 2 hour in X, Y and Z direction

Impact resistance

490m/s², each 6 time in X, Y and Z directions

Ambient temperature/humidity

0 to +40 degrees C, 45 to 85%RH

Protective structure

IP64 : key operating face, IP40 : the other

Case

Polycarbonate

Weight

Approx. 110g(including battery)

Specifications(Receiver)

Model No.	BRS-G2CR	BRS-H2CR
Direction	HEAD-ON	Front-ON
Power source	24VDC±10%
Directional angle	Full angle 90°for right/left, Full angle 40°for up/down
ID No. setting	999 kinds, turn the adjuster counterclockwise : write-in mode(from transmitter),turn the adjuster clockwise : normal mode
Indicators	Data output(OUT1 to 15) : 15 pcs, strobe output(STB) : 1 pcs, receiving lamp (RCV) : 1 pce, write-in lamp(WRT) : 1 pce, power lamp(POW) : 1 pce
Output	Output only when ID No. from transmitter would coincide with setting No. Data output 15 pcs, Strobe 1 pce, open-collector output Max.30V or less, 50mA or less
Output holding time	100msec or more
Receiving system	Pulse position modulation(455KHz), Twice coincident system
Connection	Cable(connector for the terminal end)
Ambient temperature	0 to +50 degrees C
Ambient humidity	45 to 85%RH
Ambient illuminance	4000lx(fluorescent/mercury lamp)
Environment	No corrosive gas
Vibration resistance	Double amplitude 1.5mm, 10 to 55Hz, each 2 hour in X, Y and Z direction
Impact resistance	490m/s², each 6 time in X, Y and Z directions
Insulation resistance	10MΩ(500VDC megger)
Noise resistance	Conformity standard : IEC(EN)61000-4-2/-3/-4/-6/-8
Protective structure	IP64
Case	Polycarbonate
Weight	Approx. 240g

External dimension

Transmitter

Receiver

Output circuit

NPN open-collector output
30VDC 50mA residual voltage 1.8V or less

Connection

Connector (1)12P
(JST PHR-12)

Connector (2)10P
(JST PHR-10)

Shield

Colors	Pin No.	Functions
Brown	CN1-5	OUT9
Red	CN1-7	OUT10
Orange	CN1-9	OUT11
Yellow	CN1-11	OUT12
Green	CN2-1	OUT13
Blue	CN2-3	OUT14
Purple	CN2-5	OUT15
Gray	CN2-7	STB
White	CN1-3
Pink	CN1-2
Brown/black	CN1-6	OUT1
Red/black	CN1-8	OUT2

Colors	Pin No.	Functions
Orange/black	CN1-10	OUT3
Yellow/black	CN1-12	OUT4
Green/black	CN2-2	OUT5
Blue/black	CN2-4	OUT6
Purple/black	CN2-6	OUT7
Gray/black	CN2-8	OUT8
White/black	CN1-4	COM
Pale blue	CN1-1	-VIN
Pink/black	CN2-9	+VIN
Pale blue/black	CN2-10	-VIN
Shield	Shield

Note) Don't use attached connector as relay terminal.

More Info Price

GRC-G(optical remote controller for hoist operation)

GRC-G	Optical remote controller for hoist crane
	Exclusive remote controller for hoist crane, 50 hours in continuous transmission

Features

Light source is infra-red ray and this means high reliability against noise and there is no legal regulation, too.
It is easy to handle because of light weight, approx. 330g including battery.
No interference between devices because of 64 kinds of ID

Specifications

Specifications(Transmitter)

Model No.	GRC-G3BT-Z
Power source	Alkaline cell 4 pcs(nicad battery is available)
Key operation	East, West, South, North, Up, Down, Warning, ON, OFF, 3 pcs of spare Total 12 pcs
Transmission distance	0 to 15m
Directional angle	Up/down direction : full angle 60°, right/left direction : full angle 60°
Battery life	50 hours in continuous transmission(12 hours for nicad battery)
Protective structure	IP64(IEC standard)

Specifications(Receiver)

Model No.	DM-DSP13
Power source	100 to 240VAC(±10%, 50/60Hz)
Output	Relay output : Data output --- 12 points, Strobe --- 1 point, Contact capacity : 250VAC 2.5A(inductive load)

Model No.	GRC-G2BR-W
Power source	Supplied from receiver
Directional angle	Full angle 90°
Connection	Cable with connector(2m long)
Protective structure	IP64(IEC standard)